Sensor cables are put at the outside of the target frame (left and right side). Inspect the outer 10mm of the target frame to see if any stray projectiles possibly has penetrated or snatched any cables. If so, see another chapter how to repair. Sensor cables are easily picked out of the cable channels at the sides of the target to be inspected or replaced.

If sensor cables are completely cut or short circuited, the scoring system will publish warnings, and damaged target will probably stop scoring. However, a snatched or partially damaged cable may not cause problems before it's exposed to moisture. It is therefore wise to periodically evaluate the sensor cables if stray shots has penetrated close to, or trough, the cable channels.

Remember to cover/mark the bullet holes in the target frame being inspected, to avoid a new cable inspection at the same point later.