US English (US)
NO Norwegian

Kongsberg Target Systems Knowledge

Contact us
English (US)
US English (US)
NO Norwegian
Home eScore Target Hardware articles

Target inspection procedures

    Please fill out the contact form below and we will reply as soon as possible.

    Sort By
    • Newest
    • Most likes
    • Most views
    • Inspecting and replacing the temperature shields.

      The temperature shields obtain even temperature inside the target, when target is exposed to sunlight. The temperature shields are also...

      September 23rd, 2025 29 views 0 likes

    • Inspecting the target rubber skins

      The target rubber skins need to be inspected at some intervals: Unevenness between target rubber skin and rubber band Unevenness...

      September 23rd, 2025 31 views 0 likes

    • Inspecting sensor cables (H)

      Sensor cables are put at the outside of the target frame (left and right side). Inspect the outer 10mm of...

      September 24th, 2025 40 views 0 likes

    • Inspecting the target face

      Replace target face when the aiming mark is getting unclear or distorted for the shooter. Shooters with scopes will probably...

      September 24th, 2025 33 views 0 likes

    • Inspecting and cleaning sensors (H)

      The lower sensors (behind the service panel) are rarely subjected to dust and particles as they are put far out...

      September 24th, 2025 33 views 0 likes

    • Inspecting the target service panel

      The lower part of the target has a service panel that can be opened to access the target electronics and...

      September 24th, 2025 30 views 0 likes

    Kongsberg eScore by Kongsberg Target Systems AS

    Privacy PolicyTerms of Service

    ©2025 Kongsberg Target Systems. All Rights reserved.

    Knowledge Base Software powered by Helpjuice

    Definition by Author

    0
    0