Worn rubber band is simply cut off by scissors. In this case, pay attention not to cut into the main target rubber skin.
New rubber band is installed as described below. The procedure must be done by two persons. Images below may not relate to this target model, but the installation procedure is equal to all target models:
1 | Put the rubber band slightly down (3-4cm) on top of the target. | ![]() |
2 | Spraying soap water at the outer left and right side of the rubber band will make further operations easier. | ![]() |
3 |
Twist the rubber band down and pull down/out until the rubber band get straight. It is important that both persons are synchronized and do the motions simultaneously.
|
![]() |
4 |
Again, twist the rubber band down and pull down/out until the rubber band covers the middle of the target. Adjust by pulling. There are probably marks or milling to the target frame, indicating where the rubber band is supposed to be.
|
![]() |
5 |
The end result.
|
![]() |
Positioning
It is very important that the rubber band is covering any cut-outs of the main target rubber skin - with good margins (2-3cm).